Pm Warning Level And Required Procedures - Kubota M100GX Operator's Manual

18 OPERATING THE ENGINE
BPM Warning Level and Required Procedures
During Auto Regeneration Mode when the PM level has built up in the DPF, the regeneration cycle will begin automatically.
If the regeneration cycle is interrupted or the regeneration conditions are not satisfied, the buzzer starts sounding and the
indicator display changes in response to the PM level in order to prompt the operator to perform the required procedure
listed below.
A Once the regeneration level has been reached, immediately perform the required procedure for regeneration.
Interrupting the regeneration cycle or continued operation by ignoring the warning signs may cause DPF and engine
damage.
DPF system status
PM warning level: 1
Buzzer: Not sounding
PM warning level: 2-1 If the regeneration cycle was interrupted or conditions are not satisfied for regeneration then DPF
system in now in Level 2.
Buzzer: Sounding
every 5 seconds
PM warning level: 2-2
Buzzer: Sounding
every 3 seconds
PM warning level: 3 If the regeneration fails in the warning level 2:
Buzzer: Constantly
Sounds
Engine output: 50%
PM warning level: 4 If the parked regeneration is interrupted or the tractor is continuously operated in the warning
level 3:
Buzzer: Constantly
Sounds
Engine output: 50%
Auto Mode
The regeneration indicator starts flashing.
The RPM increase
flashing.
The regeneration indicator
flashing and remain "ON" constantly.
The regeneration indicator starts flashing.
The RPM increase indicator starts
flashing.
The parked regeneration indicator starts
flashing.
The engine warning indicator starts
flashing.
The parked regeneration indicator starts
flashing.
The auto regeneration switch lamp turns
"OFF".
The engine warning indicator remains
constantly "ON".
Required procedure
A specific amount of PM has accumulated
in the DPF muffler.
Continue to work the tractor to raise the
DPF temperature.
indicator starts Continue the work and increase the engine
rpm until the indicator turns "OFF".
will stop The regeneration cycle begins until cycle is
complete then the indicator will turn "OFF".
Start the regeneration, referring to "PM
warning level: 1" above.
Now the parked regeneration indicator
starts flashing, and the parked
regeneration can also be started.
If the regeneration conditions are not met,
perform the parked regeneration.
A For the procedure, refer to "Operating
Procedure for Parked Regeneration".
Immediately discontinue working the
tractor and begin the parked regeneration
cycle process.
A For the procedure, refer to "Operating
Procedure for Parked Regeneration".
At this PM warning level, the Auto
Regeneration Mode does not function.
If the tractor is operated further, the
regeneration cycle will be disabled.
Immediately move the tractor to a safe
place and park it there and turn the engine
"OFF".
Contact your local KUBOTA Dealer.
A At this level, never continue to operate
the tractor otherwise damage will result
to the DPF and engine.