Kubota M100GX Operator's Manual page 47

8. Lower the implement.
1. Move the hydraulic control lever to "UP" position and
then move it back to "LOWEST" position.
2. If the implement does not lower and the 3-P. Lifting /
Lowering indicator starts flashing, push the 3-P. Quick
lower switch and release the position lock. (The
implement will lower and indicator light will turn off.)
Then lower the implement to the ground using the
hydraulic control lever.
(1) Hydraulic control lever
(2) 3-P. Quick lower switch
(1) 3-P. Lifting / Lowering indicator
A The implement does not go down if the 3-point hitch is
"LOCKED" with 3-point hitch lowering lock lever.
(For details, see "3-Point Hitch Lowering Lock Lever"
in "3-POINT HITCH
"HYDRAULIC UNIT" section.)
(A) "UP"
(B) "DOWN"
(C) "PUSH"
CONTROL SYSTEM"
9. Fully depress the clutch pedal, turn the
key to "START" position and release
when the engine starts.
A Because of safety devices, the engine will not start
except when the PTO clutch control switch is placed in
the "OFF" position and power shift / range shift lever is
placed in the "NEUTRAL" position.
10. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
If the lamp is still on, immediately stop the engine and
determine the cause.
C Indicators that will turn off after starting the engine
are: (1),(2),(3),(4),(5)
(1) Engine warning indicator
(2) Air cleaner indicator
(3) Engine oil pressure warning indicator
(4) Electrical charge warning indicator
(5) Master system warning indicator
11. Release the clutch pedal.
in
OPERATING THE ENGINE 25