Replacing Light Bulb; Replacing Head Lamp; Lubricating Points - Kubota M100GX Operator's Manual

138 PERIODIC SERVICE
(1) Fuse box
(2) Bolt
(3) Bolt fixed slow-blow fuse
(4) Non bolt fixed slow-blow fuse
BReplacing Light Bulb
1. Head light
Take the bulb out of the light body and replace with a
new one.
2. Other lights
Detach the lens and replace the bulb.
Light
Head light
Turn signal light (Front)
Turn signal light (Rear)
Position light (Front)
Stop light / Position light (Rear)
Work light (Hood)
Work light (CAB)
Dome light (Room lamp)
Instrument panel light
Easy checker
BReplacing Head Lamp
To avoid personal injury:
A Be careful not to drop the bulb, hit anything
against the lamp, apply excess force, and get
the lamp scratched. If broken, glass may cause
injury. Pay more attention to halogen lamps in
particular, which have high pressure inside.
A Before replacing the lamp, be sure to turn off
the light and wait until the bulb cools down,
otherwise, you may get burned.
1. While pushing the right and left lock buttons, pull and
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
4. Replace with a new bulb and reinstall the head lamp
(1) Electrical connector
(2) Rubber boot
(3) Bulb
(4) Clamping fixture
A Be sure to use a new bulb of the specified wattage.
Capacity
A Never touch the bulb surface (glass) with bare hands.
60 / 55 W
21 W
21 W
BLubricating Points
5 W
21 / 10 W
35 W
35 W
5 W
3 W
1.4 W
(1) Door hinge
(2) Rear window hinge
remove the electrical connector.
assembly in the reverse order.
(A)"Base's wider projection to face
Fingerprints, for example, may break the bulb.
upward"