Ep Setup; Printed Page Count; Permanent Page Count - Lexmark MS510 Service Manual

Printed Page Count

The value of this setting gauges the amount of usage on the printer. The value of the Printed Page Count setting will
equal the values of the Picked Sides meter. After all print tests have been completed, the value will reset to zero.
Note: The value of the setting cannot be changed manually.

Permanent Page Count

The value of this setting indicates the total amount of pages that have been printed. After all print tests have been
completed, the value will reset to zero.
Note: The Permanent Page Count value cannot be reset.
Processor ID
This is a 16‑digit hexadecimal value representing the ID of the processor on the controller card.
Engine Setting [x]
These settings are used by Engine code ECs to fix field problems. The value of [x] is any value from 1 to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area
of a supported paper size). This feature does not work in PPDS emulation.
Par S Strobe Adj
This setting adjusts the factory setting for the amount of time the strobe is sampled to determine that valid data is
available on the parallel port.
Each time the value is increased by one, the strobe is sampled 50 nanoseconds longer. Each time the value is decreased
by 1, the strobe is sampled 50 nanoseconds less than the default value. The range of values is between -4 and +6, in
increments of one. A value of zero indicates no change is made from the factory setting.

EP Setup

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help
correct print quality problems.
To restore the EP defaults:
1
From the Diagnostics menu, navigate to:
EP Setup > EP Defaults
2
Select Restore to restore the default values, or press X to exit without changing the settings.
Service menus
133
4514-630, -635, -636, -638, -639, -649