Fixing Print Quality Issues; Initial Print Quality Check - Lexmark MS510 Service Manual

4
The cooling fan turns on.
5
The fuser heater turns on.
Note: The fuser takes longer to warm up from a cold start than a warm start.
6
The main drive motor turns on.
7
The EP drive assembly drives the developer shaft located in the imaging unit.
8
The exit rollers turn.
9
The control panel indicator light blinks (MS610de only).
10
Ready appears on the display.
If no error code is displayed, but a symptom is present, go to

Fixing print quality issues

The symptoms described in this chapter might require replacement of one or more CRUs (Customer Replaceable Units)
designated as supplies or maintenance items, which are the responsibility of the customer. With the customer's
permission, you might need to install a toner cartridge.

Initial print quality check

Before troubleshooting specific print problems, complete the following initial print quality check:
1
The printer must be in a location that follows the recommended operating environment specifications. See
"Operating environment" on page
2
Check the life status of all supplies. Any supply that is low should be replaced.
3
Load 20‑lb plain letter or A4 paper. Make sure the paper guides are properly set and locked. From the control panel,
set the paper size and type to match the paper loaded in the tray.
4
Print a Menu settings page. Be sure to keep the original Menu settings page to restore the customer's custom
settings if needed.
5
Verify on the Menu settings page if the following are set to their default values:
•
Print resolution: 600 dpi
• Toner darkness: 8
6
Inspect the transfer roll for damage. Replace if damaged.
7
Inspect the toner cartridge and imaging unit for damage. Replace if damaged.
8
Print the Print quality pages to see if the problem remains. Use Tray 1 to test print quality problems.
9
Print a Print quality test page, and then look for variations in the print from what is expected. Verify if the settings
under EP Setup are set to their default values. See
10
Check to ensure the correct printer driver for the installed software is being used. An incorrect printer driver for
the installed software can cause problems. Incorrect characters could print, and the copy may not fit the page
correctly.
"Base printer symptoms" on page
287.
"EP Defaults" on page
Diagnostic information
32
4514-630, -635, -636, -638, -639, -649
108.
133.