Lexmark MS510 Service Manual page 62

Error code Description
243.02 Input sensor detected late feed during a pick retry
from tray 3.
243.03 tray 3 pass thru sensor never became covered when
feeding a sheet from an option below.
243.06 Failed to feed from tray. Paper present sensing
supported and indicates media still in tray.
243.07 Option tray 3 pass thru sensor never became
uncovered when feeding a sheet from an option
below.
243.09 Tray 3 pick motor lost encoder.
243.10 Failed to feed from tray.
243.11 Autocomp Pick / Lift Motor - Encoder never detected
in tray 3.
243.12 Motor ramp up error in tray 3.
243.13 Page to be stapled failed to feed from tray.
243.14 Sheets flushed from paper path either due to feed
error or cartridge error.
243.15 One or more trays located above the source tray 3 has
been pulled.
243.16 The engine timed out waiting for the tray 3 to report
'ready' before the 1st pick attempt.
243.17 Page was not properly picked from tray 3. Have not
exhausted all pick retry attempts as there are sheets
committed to the paper path from below.
243.19 Tray 3 fail to feed error. Detected while trying to pick
a sheet, and that leading edge was not detected by
tray sensor.
243.20 Took too long to ramp up dc feed motor in tray 3.
243.21 Pick motor stall in tray 3.
243.22 Tray 3 pick motor underspeed.
243.24 DC Feed autocompensator stalled on the last pick
attempt in tray 3.
243.32 Tray not ready.
243.33 Pick received but detected a tray pulled.
Action
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Go to "Option tray jam service check" on page
Diagnostic information
62
4514-630, -635, -636, -638, -639, -649
66.
66.
66.
66.
66.