Lexmark MS510 Service Manual page 90

Error code Description
132.01 TDS baseline too low.
132.02 TDS baseline too high.
132.03 TDS baseline excessive range.
132.16 TDS calibration at maximum.
132.17 TDS calibration too low.
132.18 TDS calibration too close to baseline.
132.32 PC drum measurement too high.
132.33 PC drum measurement too different from calibration.
132.34 PC drum measurement too close to baseline.
133.05 CTLS reading above maximum expected value.
133.06 CTLS reading below minimum expected value.
133.08 Excessive CTLS noise.
140.10 Transport motor halls not detected.
140.20 Transport motor took too long to stop.
140.30 Transport motor unable to lock (before motor ID).
140.40 Transport motor overspeed detected.
140.60 Transport motor unable to lock (after motor ID).
140.70 Transport motor out of lock detected.
140.80 Transport motor excessive PWM or overtemp.
146.00 Autocomp Pick/Lift Motor—Encoder Never Detected
in tray 1.
155.00 No encoder received from auger motor.
171.03 Fuser fan error.
171.04
171.05
171.06
171.07
Action
Go to "Toner density sensor service check" on
page 92.
Go to "CTLS service check" on page
Go to "Main drive gearbox service check" on
page 93.
Go to "Tray 1 pick/lift motor gearbox service
check" on page
Go to "Cartridge gearbox service check" on
page 94.
Go to "171.xx Cooling fan service check" on
page 95.
Diagnostic information
90
4514-630, -635, -636, -638, -639, -649
93.
95.