LED Illumination
Parameter # F0h, ADh
Select whether to use internal LED illumination (provided by the Symbol MS440X), external illumination (provided
outside the Symbol MS440X), or both.
This parameter only applies for decoding if you enabled
you enabled
Image Capture Illumination on page
Illumination, all illumination is off for that mode, regardless of this LED Illumination setting.
Internal Illumination
(00h)
Internal and External Illumination
(02h)
Snapshot Mode Timeout
Parameter # F0h, 43h
This parameter sets the amount of time the imager remains in Snapshot Mode. The imager exits Snapshot Mode
upon a trigger event, or when the Snapshot Mode Timeout elapses. To set this timeout value, capture the bar code
below followed by a bar code from
seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90 seconds, etc.
Snapshot Mode Timeout
Decoding Illumination on page
7-10. If you disabled Decoding Illumination or Image Capture
Appendix D, Numeric Bar
Codes. The default value is 0 which represents 30
Imager Preferences 7 - 13
7-6, or for image capture if
*External Illumination
(01h)