Installing The Fuel Pump; Installing The Sub-Frame - Yamaha YP400T Service Manual

THROTTLE BODY AND FUEL INJECTOR
2
4
6
È
1
3
a
2
4
3
1
1
5
b
2
3
7 - 32

INSTALLING THE FUEL PUMP

1. Install:
• fuel pump
4 Nm (0.4 m · kg, 2.9 ft · lb)
NOTE:
• Do not damage the installation surfaces of
the fuel tank when installing the fuel pump.
• Always use a new fuel pump gasket.
• Align the projection a on the fuel pump with
the alignment mark b on the fuel tank.
• Tighten the fuel pump bolts in the proper
tightening sequence as shown and torque
them in two stages.
È Forward

INSTALLING THE SUB-FRAME

1. Install:
• sub-frame adjusting bolts 1
• sub-frame rear mounting bolts 2
• sub-frame front lower mounting bolts 3
• sub-frame front upper mounting bolts 4
NOTE:
Do not fully tighten the bolts.
2. Tighten:
• sub-frame rear mounting bolts
54 Nm (5.4 m · kg, 39 ft · lb)
NOTE:
Tighten the bolts on the left side of the scooter
first.
3. Tighten:
• sub-frame front lower mounting bolts
54 Nm (5.4 m · kg, 39 ft · lb)
NOTE:
Tighten the bolt on the left side of the scooter
first.
FI