Yamaha YP400T Service Manual page 154

1
2
1
2
3
a
FRONT AND REAR BRAKES
3. Measure:
• brake pad wear limit a
Out of specification → Replace the brake
pads as a set.
4. Install:
• brake pad springs 1
• brake pads 2
• rear brake caliper
NOTE:
Always install new brake pads, and new brake
pad springs as a set.
M MMM
a. Connect a suitable hose 1 tightly to the
brake caliper bleed screw 2. Put the other
end of this hose into an open container.
b. Loosen the brake caliper bleed screw, and
then turn the brake caliper piston 3 clock-
wise until section a of the brake caliper pis-
ton is level with the surface of the brake
caliper body.
NOTE:
Align the recesses b in the brake caliper pis-
ton with the brake caliper body as shown in the
illustration.
c. Tighten the brake caliper bleed screw.
3
b
4 - 16
CHAS
Brake pad wear limit
0.8 mm (0.03 in)
M MMM M M MMM M M MMM M M MMM
Brake caliper bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
M M MMM M MMM