Yamaha YP400T Service Manual page 196

LS
a
1
2
a
1
HANDLEBAR
5. Install:
• rear brake lock lever cable 1
NOTE:
Lubricate the inside of the rear brake lock lever
cable and rear brake lock lever with a thin coat
of lithium-soap-based grease.
1
6. Install:
• left handlebar switch 1
b
NOTE:
Align the projection a on the left handlebar
switch with the hole b in the handlebar.
1
7. Install:
• front brake master cylinder 1
• front brake master cylinder holder 2
NOTE:
• Make sure to install the brake master cylin-
der holder that has the "R" mark.
• Install the front brake master cylinder holder
with the "UP" mark facing up.
• Align the end of the front brake master cylin-
der holder with the punch mark a in the han-
dlebar.
• First, tighten the upper bolt, then the lower
bolt.
8. Install:
LS
• throttle grip
• throttle cables 1
NOTE:
_
Lubricate the inside of the throttle grip with a
thin coat of lithium-soap-based grease and
install it onto the handlebar.
4 - 58
CHAS
6 Nm (0.6 m · kg, 4.3 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)