Yamaha YP400T Service Manual page 231

VALVES AND VALVE SPRINGS
2. Replace:
• valve guide
NOTE:
_
To ease valve guide removal and installation,
and to maintain the correct fit, heat the cylinder
head to 100 °C (212 °F) in an oven.
M MMM
a. Remove the valve guide with the valve
guide remover 1.
b. Install the new valve guide with the valve
guide installer 2 and valve guide remover
1.
c. After installing the valve guide, bore the
valve guide with the valve guide reamer 3
to obtain the proper valve-stem-to-valve-
guide clearance.
NOTE:
_
After replacing the valve guide, reface the
valve seat.
L LLL
3. Eliminate:
• carbon deposits
(from the valve face and valve seat)
4. Check:
• valve face
Pitting/wear → Grind the valve face.
• valve stem end
Mushroom shape or diameter larger than
the body of the valve stem → Replace the
valve.
5. Measure:
• valve margin thickness a
Out of specification → Replace the valve.
5 - 24
ENG
M MMM M M MMM M M MMM M M MMM
Valve guide remover (5 mm)
90890-04097, YM-04097
Valve guide installer (5 mm)
90890-04098, YM-04098
Valve guide reamer (5 mm)
90890-04099, YM-04099
L LLL L L LLL L L LLL L L LLL
Valve margin thickness
0.85 ~ 1.15 mm
(0.0335 ~ 0.0453 in)
M M MMM M MMM
L L LLL L LLL