Yamaha YP400T Service Manual page 152

FRONT AND REAR BRAKES
3. Measure:
• brake pad wear limit a
4. Install:
3
• brake pad shims 1
• brake pads 2
1
• brake pad springs 3
NOTE:
2
_
Always install new brake pads, new brake pad
shims, and a new brake pad springs as a set.
3
M MMM
a. Connect a clear plastic hose 4 tightly to the
b. Loosen the bleed screw and push the brake
c. Tighten the bleed screw.
d. Install new brake pad shims, new brake
L LLL
5. Lubricate:
• front brake caliper retaining bolts
CAUTION:
_
• Do not allow grease to contact the brake
pads.
• Remove any excess grease.
4 - 14
Out of specification → Replace the brake
pads as a set.
Brake pad wear limit
0.8 mm (0.03 in)
M MMM M M MMM M M MMM M
bleed screw 5. Put the other end of the
hose into an open container.
caliper pistons into the brake caliper with
your finger.
Bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
pads and new brake pad springs.
L LLL L L LLL L L LLL L
Recommended lubricant
Lithium-soap-based grease
CHAS
M MMM M M MMM M MMM
L LLL L L LLL L LLL