Yamaha YP400T Service Manual page 23

1
1
1 - 7
FEATURES
To reset the oil change indicator
1. Turn the key to "ON".
2. Hold the reset button pushed for two to
eight seconds.
1 Reset button "OIL CHANGE"
3. Release the reset button, and the oil
change indicator will go off.
NOTE:
If the engine oil is changed before the oil
change indicator comes on (i.e. before the
periodic oil change interval has been reached),
the indicator must be reset after the oil change
for the next periodic oil change to be indicated
at the correct time. To reset the oil change
indicator before the periodic oil change interval
has been reached, follow the above proce-
dure, but note that the indicator will come on
for 1.4 seconds after releasing the reset but-
ton, otherwise repeat the procedure.
V-belt replacement indicator "V-BELT"
This indicator flashes
(12,500 mi) when the V-belt needs to be
replaced.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the key to "ON" and make sure that the
engine stop switch is set to "
2. If the indicator does not come on, check the
electrical circuit. Refer to "SIGNALING
SYSTEM" in chapter 8.
To reset the V-belt replacement indicator
1. Turn the key to "ON" and make sure that the
engine stop switch is set to "ON".
2. Disconnect the V-belt replacement reset
coupler 1 for two to ten seconds.
3. And then, connect the V-belt replacement
reset coupler, the V-belt replacement indica-
tor will come on for 1.4 seconds.
And the V-belt replacement indicator will go
off.
NOTE:
If the V-belt is replaced before the V-belt
replacement indicator comes on (i.e. before
the V-belt replacement interval has been
reached), the indicator must be reset after the
V-belt replacement for the next periodic V-belt
replacement to be indicated at the correct
time.
GEN
INFO
every 20,000 km
".