Yamaha YP400T Service Manual page 180

1
a
3
2
3
FRONT AND REAR BRAKES
2. Install:
• brake caliper piston 1
NOTE:
1
Align the recesses b in the brake caliper pis-
ton with the brake caliper body as shown in the
illustration.
3. Install:
• brake caliper bracket
b
4. Install:
1
• brake caliper (temporarily)
• brake hose 1
• copper washers
• union bolt 2
_
Proper brake hose routing is essential to
insure safe vehicle operation. Refer to
"CABLE ROUTING" in chapter 2.
When installing the brake hose onto the
brake caliper 3, make sure the brake pipe
touches the projection a on the brake cali-
per.
5. Remove:
a
• brake caliper
6. Install:
• brake pad springs
• brake pads
• brake caliper retaining bolts
7. Fill:
• brake master cylinder reservoir
4 - 42
Turn the brake caliper piston clockwise until
section a of the brake caliper piston is level
with the surface of the brake caliper body.
40 Nm (4.0 m · kg, 29 ft · lb)
New
30 Nm (3.0 m · kg, 22 ft · lb)
WARNING
CAUTION:
27 Nm (2.7 m · kg, 19 ft · lb)
Refer to "REPLACING THE REAR BRAKE
PADS".
(with the specified amount of the recom-
mended brake fluid)
CHAS