Step-By-Step Guide - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd
S - -S G
TEP BY TEP
Preliminaries
do this:
IMPORTANT!
do this:
do this:
Manual filename: Elgar Manual v4.4x.doc
English version
UIDE
This section guides you through setting up the unit for basic operation. You may
find this useful if you have not used the Elgar Plus for a while.
The Control Summary sheet details the menu structure and outlines the use of
the front panel controls. For more information, see the Function Menu section
on page 18.
For digital interfaces, use with cables designed for digital audio:
•
for AES/EBU interfaces use 110Ω screened, twisted pair cables fitted with
one male XLR connector and one female XLR connector.
•
for SDIF, Wordclock or SPDIF BNC interfaces, use 75Ω coax cables fitted
with BNC plugs.
•
for SPDIF RCA interfaces, use 75Ω coax cables fitted with RCA Phono
plugs.
•
for TOSLINK optical interfaces, use Toslink fibre-optic cables.
•
for ST optical interfaces, use ST style fibre optic cables.
•
for IEEE 1394 interfaces, use the IEEE 1394 cable provided with the unit.
For analogue inputs / outputs, use with screened cables of the correct type:
•
for balanced inputs / outputs, use screened, twisted pair cables fitted with
one male XLR connector and one female XLR connector.
•
for unbalanced inputs / outputs, use coax cables fitted with RCA Phono
plugs.
Connect the power cable supplied to the power inlet on the Elgar Plus rear
panel, plug the other end into a convenient power outlet.
Please do not use an excessively thick power cable as this may damage the
power inlet connector.
Press the
Standby
configures itself.
The display will show in sequence:
If the unit is likely to be set in an unfamiliar state, you can reset it as follows:
Hold down the
Display
then press the
Display
Press the button and wait while the unit reboots.
Vol/Bal
The and one of the input indicators will be lit.
PWR, MUTE
button and wait about 30 seconds while Elgar Plus
Elgar +, Testing ...
button and press the
button repeatedly until the display shows Factory.
Page 8
Manual for Software Issue 4.3x
August 2005
and
No Input.
button to open the menu,
Vol/Bal
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk