Using Elgar Plus With A Standard Purcell And A Cd Player; Figure 6 - Using Elgar Plus With Purcell And A Cd Player - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd

Using Elgar Plus with a Standard Purcell and a CD Player

DIGITAL OUT
RCA phono
cable
L
L
XLR
cables
Balanced
Outputs
To Power Amplifier or Preamplifier
do this:
do this:
do this:
Manual filename: Elgar Manual v4.4x.doc
English version
If your Purcell is not 1394-equipped, you can still upsample the output from a
standard CD player to 24 bit 192kS/s.
DIGITAL INPUTS WORDCLOCK
AES RCA ST A
PUSH
BNC TOSLINK IN
R OUTPUT L AES 1 AES 2
LEVEL
PUSH PUSH
HIGH
R
LOW
R R L
RCA phono
cables
Unbalanced
- or -
Outputs

Figure 6 - Using Elgar Plus with Purcell and a CD player

Connect up as shown above.
Purcell setup:
Open the menu and run the
digital inputs to the CD player - use Purcell's
button to set the
Output
Elgar Plus setup:
Open the menu, run the
select AND
AES 1 AES 2
listening level. Open the menu again and choose a different
L
Hand Crafted by
The Red Hot CD Player Co.
R
BNC
cable
DIGITAL OUTPUTS
B AES1 AES2 RCA
OUT BNC
XLR
cables
RCA1 A ST CH1
DSD / SDIF
RCA2 BNC TOSLINK
IN - WORDCLOCK - OUT
Factory
routine. You can connect any of Purcell's
44.1→ → → → 192
conversion.
Factory RstSync
and
inputs. Use the
Volume
Page 16
Manual for Software Issue 4.3x
August 2005
dCS Purcell Upsampler
OPTION POWER
SUC
1394
dCS Elgar Plus DAC
B
CH2 SUC POWER
1394
REC OUT
button to select it. Use the
Input
routines. Use the
Input
control to set a comfortable
Filter
if you wish.
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
button to