DCS Elgar Plus User Manual page 31

dCS Elgar Plus User Manual
dCS Ltd
do this:
do this:
do this:
OOPS!
do this:
do this:
do this:
Manual filename: Elgar Manual v4.4x.doc
English version
If there is anything wrong with the dCS CD that has been loaded or it does not
match the product, the unit will display
revert to normal operation. Don't worry – the internal software is unchanged.
Check the CD for dust or scratches.
If it is not a dCS CD at all, the unit will keep repeating
about 30 seconds or display
If the data is correct, the unit will display
You can move the Transport on to track n, or wait for it to get there of its own
accord.
If the unit has to wait for the right track, it will display
2, etc, until it finds the right one.
Found Track
(this is the new software issue number). If the unit displays
the procedure but manually advance the transport to track n.
Next, the update progress is displayed in one of the following formats:
•
The display counts up from
up from to
0% 1/7
section is loaded and copied. Some models may use less than 8 sections.
•
A moving dot counts down slowly from about
After about 15 minutes, the update is complete and the unit will reboot itself.
If the CD is still playing, you can stop it now.
If the unit being updated has a 1394 interface, wait until the unit has settled
(about 30 seconds), switch it off for 10 seconds, then on again.
If the unit detects no change in the 1394 interface code, it will boot up as usual
and be ready for use.
If the 1394 interface code has been updated, the unit will load the new code into
the flash memory on the 1394 interface board – this takes about 10 minutes.
While this is taking place, the unit will display a progress bar. Next the unit will
display in sequence:
Done
The unit is ready for use.
If the CD transport stops or becomes disconnected during an update, don't
worry! The original software is backed up inside the unit. Proceed as
follows:
The checking routine will find a sequencing error and
appear on the display.
Turn the power off and on to reboot. This message will scroll across the display:
Bad CheckSum – Press Function button to attempt recovery
or
Bad CheckSum – Press Mute button to attempt recovery
or
Bad CheckSum – Press Menu button to attempt recovery,
depending on the model.
Press the appropriate button once.
The original software is retrieved from the internal backup while displaying
. This may take a few minutes. When recovery is complete, the unit
Wait...
re-boots.
CD Update
Run the routine again to load the new software.
Wrong!
and then revert to normal operation.
Wrong CD
Track
to
0% 0/7 99%
1/7, displays
99% Copying
4, ...,
5, Done Done 1
Page 31
Manual for Software Issue 4.3x
August 2005
or or
Wrong CD No Index
Please Start
n, where n is a number.
Found Track
will appear on the display
Vx.xx
Track, repeat
No
0/7, displays Copying, counts
and so on until the last
to 0.
3
then reboot itself again.
or
Non Seq Bad CD!
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
and
CD, for
1, then
will