Step-By-Step Guide; Cables; Powering Up; Loading A Default Set-Up - DCS 905 User Manual

dCS 905 User Manual
dCS Ltd
S - -S G
TEP BY TEP
Preliminaries

Cables

Powering Up

Loading a Default Set-up

Manual filename: dCS905 Manual v1.0x Eng.doc
English version
UIDE
This section guides you through setting up the unit for basic operation. You may
find this useful if you have not used the dCS 905 for a while.
The Menu Guide sheet details the menu structure. For more information, see
the Menu section, starting on page 14.
Connect up with cables designed for digital audio:
•
for AES/EBU interfaces use 110Ω screened, twisted pair cables fitted with
one male XLR connector and one female XLR connector.
•
for DSD/SDIF or Word Clock interfaces, use 75Ω coax cables fitted with
BNC plugs.
For analogue inputs, use screened, twisted pair cables fitted with one male XLR
connector and one female XLR connector.
Connect power to the unit. If there is a power switch next to the power inlet on
the rear panel, ensure it is set to on. Press the
about 20 seconds while the unit configures itself. The display will show
Analogue to Digital Converter, followed by
has booted up, either the meter display or status display will appear.
The following routine sets the unit to a defined state – you will not have to do
this every time you power up as the unit remembers the last set-up before
power-down.
To open the menu, press the
button twice to open the
Fixed Stores menu, then press the
prompt you to press one of the
seconds for the settings to be loaded, then hold down the
seconds to exit the menu.
x
x
x
Menu button. Press the
Recall Settings menu. Press
OK button to load
F buttons to confirm the action. Wait a few
Page 8
Manual for Software Issue 1.0x
November 2006
On/Off button and wait for
Please wait ... . When the unit
↑ ↑ ↑ ↑
button then the
↓ ↓ ↓ ↓ then OK to open the
Store A. The display will
Cancel button for few
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
dCS905
OK