Burn In - Burn-In Signal Generation; Test - Display Test - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd
Burn In Burn In Burn In Burn In
- Burn-In Signal Generation
IMPORTANT!
IMPORTANT!
do this:
do this:
do this:
do this:
Test Test Test Test
- Display Test
do this:
do this:
Manual filename: Elgar Manual v4.4x.doc
English version
A second burst of noise appears on both channels with the right channel
inverted for several seconds.
This is displayed briefly at the end of the test.
If both channels are in-phase the first burst of noise will produce a stable central
image but the second burst will not. If one channel is out of phase, the second
burst will produce a stable stereo image but the first will not.
If there is a phasing error, check for wiring errors from the unit output onwards.
You cannot correct this error on a dCS DAC using the
inverts both channels.
Read all the steps in this section before starting the System Burn-in routine.
The Burn-in routine outputs a signal at maximum volume.
This routine is NOT suitable for burning-in loudspeakers. Ensure your
loudspeakers are disconnected, or your power amplifier is switched off
before starting this routine.
Use this feature to burn-in your system components with modulated pink noise.
It is disabled when in DSD/SACD mode.
Set up your system volume control to the usual setting.
Open the Menu and step through until the display shows:
Press the button once to start the burn-in routine.
Select
Elgar Plus will show the warning messages
display for 20 seconds and then the burn-in signal will ramp-up from zero to
maximum level over a period of about 10 seconds.
The display cycles through
routine is running.
To stop the Burn-in signal, press either a
display will briefly show:
This runs a test routine to ensure the display is working correctly.
Open the Menu and step through until the display shows Test.
Press the button once to start the test.
Select
•
The main display lights up then fades from bottom to top.
•
The indicator LEDs light up briefly in sequence.
•
All indicators light up, along with small squares on the main display. This
flashes off and on once.
•
The display shows Done.
Done
Burn In
Burn in, Caution
Done
Page 28
Manual for Software Issue 4.3x
August 2005
Phase
feature as this
and
Caution Loud
and while the
Loud
or button once. The
Step Select
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
in the main
Burn In