Mains Voltage Setting; Positioning The Unit - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd

Mains Voltage Setting

IMPORTANT!

Positioning the Unit

Manual filename: Elgar Manual v4.4x.doc
English version
Before connecting the power cable to your Elgar Plus for the first time, please
check that it has been set to the correct operating voltage for your local mains
supply. 50Hz or 60Hz operation is not important – the unit can use either. The
unit's present voltage setting is shown on the label beneath the mains inlet on
the rear panel. If this does not match your local supply voltage, DO NOT
attempt to use the unit. Contact your dealer to arrange to have the unit reset.
Using the Elgar Plus with the wrong mains setting for your local supply may
result in serious damage to the unit and will invalidate the warranty. DO NOT
attempt to reset the unit yourself.
Please use a sensible power cable, such as the one supplied with the unit.
Some audiophile power cables presently available are excessively heavy,
their weight can damage the power inlet connector. Such damage is not
covered by the warranty.
Place Elgar Plus on a firm, vibration free base so as to allow convenient
connection to your digital source. We suggest that you avoid siting Elgar Plus
either directly above or below preamplifiers or tuners, if either of these will be
used in your system at the same time as Elgar Plus.
Page 55
Manual for Software Issue 4.3x
August 2005
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk