Step 3 - Setting The Output Level; Figure 2 - Output Level Switch - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd

Step 3 - Setting the Output Level

do this:
L
Manual filename: Elgar Manual v4.4x.doc
English version
If the preamplifier volume setting for a comfortable listening level is too high or
too low, you may need to change the
driving a power amplifier directly and Elgar Plus
comfortable listening level is higher than
the setting.
Output Level
The switch is located on the back panel. If the Volume setting is
Output Level
too high, set it to the
Low
position.
High
R OUTPUT L AES 1 AES 2
LEVEL
PUSH PUSH
HIGH
R
LOW
Figure 2 – Output Level switch
Output Level
–10.0
position. If the Volume setting is too low, set it to the
RCA1 A ST CH1 CH2
DSD / SDIF
RCA2 BNC TOSLINK
IN - WORDCLOCK - OUT
Page 12
Manual for Software Issue 4.3x
August 2005
setting. Similarly, if you are
setting for a
Volume
or lower than try changing
–20.0
B
SUC POWER
1394
REC OUT
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk