Using The Function Menu; Opening The Menu; Types Of Menu Page; Closing The Menu - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd

Using the Function Menu

Opening the Menu

Types of Menu Page

Closing the Menu

Manual filename: Elgar Manual v4.4x.doc
English version
The Function Menu gives the user access to a wide range of additional
features. It also allows new features and performance enhancements to be
added at a later date by software upgrades.
The Function Menu is controlled by two buttons:
•
press and
Vol/Bal
•
the button doubles as the
Vol/Bal
•
the button pages forward through the Menu - the
Display
If you have a dCS Remote Control, you can use this to access the menu:
•
the button opens the Menu and doubles as the
Function
• ↑ ↑ ↑ ↑
the button pages forward through the Menu - the
• ↓ ↓ ↓ ↓
the button pages backward through the Menu - the
When you first open the Function Menu, the display will show Menu.
Successive presses of the
directly to any particular page, but must enter at the top of the Menu and then
page through until you reach the page you want.
There are three types of page in the Menu - Parameter Pages, Information
Pages and Test Pages.
Parameter pages allow the user to check and also change the current settings
of the operating parameters, for example Filter. When a parameter page is
displayed, the first press of the
Subsequent presses of the
Information pages display information about the unit, for example Software
Issue. When an information page is displayed, pressing the
displays the information held on that page.
Test pages allow the user to initiate a number of useful routines, for example
Channel Check. When a Test page is displayed, pressing the
starts the test routine.
There are two ways to close the menu and return to normal operation. The
easiest way is to wait 5 seconds for the unit to time-out and revert to the
standard display. Alternatively, use the
display shows and then press the
End
If the unit times out before the operation in hand has been completed, simply re-
enter the menu, page forward (or backward) and continue where you left off. If
you find the 5 second time-out difficult to use, you can extend it to 30 seconds
TimeOut
by changing the
buttons at the same time to open the Menu.
Display
Select
button page through the Menu. You cannot go
Step
button shows the current setting.
Select
button change the page setting.
Select
Step
Select
setting to Long.
Page 19
Manual for Software Issue 4.3x
August 2005
button.
button.
Step
Select
button.
Step
Step Back
Select
Select
button to page forward until the
button once.
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
button.
button.
button
button