Maintenance And Support; Service & Maintenance; Obtaining Service; Mains Fuse - DCS Elgar Plus User Manual

Dcs elgar plus stereo digital to analogue converter
Hide thumbs Also See for Elgar Plus:
Table of Contents

Advertisement

dCS Elgar Plus User Manual
dCS Ltd
M
AINTENANCE AND
Service & Maintenance

Obtaining Service

Mains Fuse

IMPORTANT!

Replacing a Blown Fuse

IMPORTANT!
Manual filename: Elgar Manual v4.4x.doc
English version
S
UPPORT
dCS audio products are designed not to need regular maintenance, and contain
no user serviceable parts apart from the mains fuse.
If you experience problems with your Elgar Plus, you should check the
"Troubleshooting" section on page 64. You may be able to resolve the situation
yourself (for example, by changing a menu setting).
If this does not resolve the problem, contact your authorised dCS dealer for
advice, quoting the model, the full serial number (see
software version number (see
description of the fault. If further action is necessary, your dealer will advise you
fully.
There is a mains fuse below the power inlet, accessible from the outside of the
unit. If the fuse blows, it may be changed by the user. The current consumption
of the unit is very low, so it only blows if power surges occur, or there is a fault
in the unit. Usually, power surges cause no other damage, but if the fuse blows
repeatedly on replacement, some other damage will have been done and the
unit must be returned to dCS for repair.
Fuse Type: 20 x 5mm 0.5 amp T HRC fuse
If the fuse should fail, it is essential that it be replaced with one of the same
type and rating. Failure to do so could result in damage to the unit, risk of
fire or electric shock and will invalidate the guarantee.
Referring to
12, remove the power cable, use a small flat bladed
Figure
screwdriver to pry up the tab on the fuse carrier (A) and pull it out. Push the
blown fuse out of the clip in the carrier (B) and dispose of it. Fit a new fuse in
the clip (C) and push the carrier back into the unit so that it clicks home. Spare
fuses are provided with the unit.
A
Figure 12 – Changing the Mains Fuse
Disconnect the power cable before changing the fuse.
Issue
on page 29) and giving a detailed
x
B
Page 58
Manual for Software Issue 4.3x
August 2005
Serial
on page 29), the
C
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk

Advertisement

Table of Contents
loading

Table of Contents