dCS Elgar Plus User Manual
dCS Ltd
The unit fails to respond to the controls
The Main Display turns on briefly when a control is operated, then turns off
The Left and Right channels are swapped
One audio output channel is low or absent
The sound has a peculiar tonal balance
Crackles or pops occur while playing music
Manual filename: Elgar Manual v4.4x.doc
English version
•
Check that the
STBY
button to return to normal operation. Alternatively, switch off, wait 10
seconds and switch on – Standby mode will be cancelled.
•
While locking to a source or changing some settings (e.g. Filter), the
microcontroller inside Elgar Plus is busy and will not respond to new
commands for a few seconds.
•
If the Mute fade-out rate is set to Mute-Slw, the unit may be unresponsive
for a few seconds while slow muting is in progress (see page 22)
•
Short mains supply drop-outs may cause the microcontroller to lock up.
Switch off the unit, wait 10 seconds then switch on again. If this does not
clear the fault, please contact your dealer.
•
This happens when the
any other brightness setting to stop the display blanking out (see page 24).
•
Check that the audio output cables are not reversed.
•
Open the menu and page through until the
set to Swap-On, change it to
•
Check that the channels are not swapped elsewhere in the system.
•
Dual AES
If you are using
the output on the source equipment carrying the Left channel data (probably
labelled AES1 or AES A) and the
the source equipment carrying the Right channel data (probably labelled
AES2 or AES B). See the manual for the source equipment for information,
and also page 23.
•
Check that the
Balance
page 37).
•
Check that the audio output cables are connected correctly and are not
damaged.
•
Check that the balance is not offset elsewhere in the system.
•
Set De-Emphasis to
•
If this fails to correct the problem, the De-Emphasis flags in the data stream
may be incorrectly set (this is rare but it does happen). To find the correct
De-Emphasis characteristic, change the De-Emphasis setting to 50/15µs,
CCITT
Off
or
in turn until the correct setting is found. When you change to a
different disk or tape, we recommend setting
•
The source may have a high level of jitter. Try setting the
PLL:Wide. See page 25.
•
The digital audio cable connecting Elgar Plus to the source may be
damaged, intermittent or of the wrong type. Some expensive cables are not
correctly designed for digital audio use. Try another cable.
•
The CD may be dirty - clean it very carefully using a radial motion.
•
The disk / tape may be damaged or contain corrupted data.
•
The audio output level may be enough to overload a preamplifier or power
amplifier.
indicator is not lit - if so press the
Display Brightness
Swap-Off.
mode, ensure that
input is connected to the output on
AES 2
control is correctly set (see
Auto
– see page 35.
Page 66
Manual for Software Issue 4.3x
August 2005
Power/Standby
is set to
0. Change to
Bright
Swap
page is displayed. If it is
input is connected to
AES 1
Rotary Control
De-Emph
Auto
to
again.
PLL
parameter to
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
on