Ch.check - Channel Check Test; Ph.check - Phase Check Test - DCS Elgar Plus User Manual

dCS Elgar Plus User Manual
dCS Ltd
Ch.Check Ch.Check Ch.Check Ch.Check
- Channel Check Test
do this:
do this:
do this:
Ph.Check Ph.Check Ph.Check Ph.Check
- Phase Check Test
do this:
do this:
do this:
5
The ear responds to positive pressure substantially more than it does to negative pressure for low
frequencies, so it is worth getting the phasing correct.
Manual filename: Elgar Manual v4.4x.doc
English version
Use this feature to check if the stereo outputs on your system are swapped. It is
disabled when in DSD/SACD mode.
Set up your system to play music at a comfortable level.
Open the Menu and step through until the display shows:
Press the button once to start the test. After briefly displaying Wait, the
Select
following sequence occurs:
A modulated tone should appear on the left channel only for several seconds.
Both outputs are muted for a second.
A modulated tone should appear on the right channel only for several seconds.
This is displayed briefly at the end of the test.
If the channels are swapped, check for wiring errors from the unit output
onwards. If you correct this temporarily using the
Swap
note that the setting is NOT remembered at power down.
Use this feature to check if one channel in your system is phase inverted
disabled when in DSD/SACD mode.
Set up your system to play music at a comfortable level.
Open the Menu and step through until the display shows:
Press the button once to start the test.
Select
After briefly displaying Wait, the following sequence occurs:
In-phase noise appears on both channels for several seconds.
Both outputs are muted for a second.
Ch.Check
Left
None
Right
Done
Ph.Check
Normal
None
Inverted
Page 27
Manual for Software Issue 4.3x
August 2005
Swap
function on a dCS DAC,
email: more@dcsltd.co.uk
web-site: www.dcsltd.co.uk
5
. It is