Maintenance And Support; Hardware; Service & Maintenance; User Changeable Parts - DCS 900E User Manual

dCS 900E / 902E User Manual
dCS Ltd
M S
AINTENANCE AND

Hardware

Service & Maintenance
dCS audio products are designed not to need regular maintenance, and contain
no user serviceable parts:
•
there are no moving parts,
•
there are no short life or wear-out parts used,
•
the units have no holes through which liquids or
•
contamination can normally enter,
•
no dust deposits build up to degrade performance.
All parts are replaceable or upgradeable by dCS, for a period of at least five
years from the date you purchased your unit. If your unit is damaged in some
way, please contact your Distributor or dCS.

User Changeable Parts

There are no user serviceable parts inside the case. Routine maintenance is
not necessary and repairs are generally carried out by dCS, since this allows us
to thoroughly verify the results before shipment.
There is a mains fuse in the mains socket, accessible from the outside of the
unit. This may be changed by the user. The current consumption of the unit is
very low (150 mA at 110 V) so it only blows if there is a fault - usually if the unit
is set to its low voltage setting (100 - 120V) but has been plugged into a high
voltage mains (220 - 240V). Usually no other damage is caused, but if the fuse
blows repeatedly on replacement, some other damage will have been done and
the unit must be returned to dCS for repair.
Fuse Type :
If the fuse should fail, it is essential that it be replaced with one of the same type.
Failure to do so could result in damage to the unit and may invalidate the
guarantee. To gain access to the fuse, remove the IEC mains connector, use a
small flat bladed screwdriver to pry up the tab on the fuse carrier and pull it out.
Push the fuse out of the clip in the carrier and replace it with a new one. Push
the carrier back into the unit so that it clicks home.
IMPORTANT!
Disconnect from the mains before changing the fuse.
Manual part no: DOC0029021E1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
All manuals and user guides at all-guides.com
UPPORT
20 x 5mm 2 amp HRC fuse
MAINS FUSE 2A(T) ON OFF
Figure 30 – Changing the Mains Fuse
Page 56
Manual for Software Versions 1.3x to 1.5x
Remove
old fuse
Document No: OS-MA-D0002-902.1E1
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk
th
12 June 2000
Fit
new fuse