dCS Bart
DAC User Manual
ók
DISPLAY SETTINGS Menu
Brightness
Set the display
Menu
button to exit.
Display On/Off
This page is usually set to On.
When set to
display will turn on briefly when a control setting is changed. The display will stay on if
the menu is open.
Logo On/Off
When set to On, the dCS logo at the left side of the display is illuminated.
When set to Off, the logo is not illuminated.
GENERATOR Menu
Channel Check
This routine tests the system for swapped channels. A tone is output on the left channel
only while the display shows
shows
Right
swapped somewhere in your system.
Phase Check
This routine tests the system for phase reversals. Noise is output in phase on both
channels while the display shows
channel is inverted while the display shows
central image, the second burst should not. If these are the wrong way around, one
channel in your system is phase inverted.
Burn In
This page runs a procedure to condition your system. The unit displays
Warning –
ramps up and down slowly in level. Press any button to stop the procedure.
Please ensure that the volume level is reasonable, as careless use of the
!
can damage your amplifiers and loudspeakers. dCS will not be liable for such damage.
Bartok DAC Manual v1_0x
Brightness
to a comfortable level using the
Off
and the menu closes, the display will turn off after a few seconds. The
Left
Channel, then the right channel only while the display
Channel. If these are the wrong way around, the left and right channels are
Loud!,
Press any button to quit,
In
Phase. After a few seconds, the noise on the right
Out
Phase. The first burst should produce a
then outputs modulated pink noise that
Page 45
Software Issue 1.0x
February 2019
◄
or
►
buttons. Press the
Burn In
Burn In
feature
English version