Operation Preview Function - FOR-A MFR-1616 Operation Manual

6-4. Operation Preview Function

The Operation Preview function allows you to set an output to be used for the preview.
(ex.) When pressing a source button on the remote control panel for setting a simultaneous
crosspoint switch, the selected source will be output to the preview output. Then you can
check source images to be assigned to the simultaneous crosspoint switch before pressing
TAKE. In addition, when pressing a destination button, the source channel assigned for the
destination channel will be output to the preview output.
 Assigning Operation Preview to a Button on the Remote Control Panel
The Operation Preview function is disabled as default. To enable the function, assign the
function to a button on the remote control panel in the Web-based Control.
Only MFR-39RU and MFR-16RUD units can assign Operation Preview on the front panel
operation.
 See [Web-based Control: Assign Function page ].
 See sections 5-3-3-12. "BTN ASSIGN" and 5-4-2." Button Assignment Change."
 Enabling the Operation Preview function
Press the O-PREVIEW button on each remote control unit to enable the function.
The preview signal will output to the set destination channel.
81