Crosspoint Control; One Crosspoint Switching; One Crosspoint Switching By X-Y Setting - FOR-A MFR-1616 Operation Manual

6. Crosspoint Control

6-1. One Crosspoint Switching

There are two ways of switching crosspoints: Switching a crosspoint one at a time, or switching
multiple crosspoints simultaneously. This section describes the switching of one crosspoint.

6-1-1. One Crosspoint Switching by X-Y Setting

A crosspoint can be switched by using the destination and source buttons on the remote
control panel.
Destination and source channels must be assigned to those buttons beforehand.
 See section 5-3-3-12 "BTN ASSIGN" for details on assigning channels to buttons.
(Ex.) The procedure to output source channel 8 to destination channel 4.
Step
Press a destination button to
select destination channel 4.
1
Press a source button to select
source channel 8.
2
 Destination and source channels can also be selected by the control knob or using the
display. To select channels by the control knob, the mode menu must be set to destination
mode or source mode using the MODE button(s). (Supported only for MFR-39RU and
MFR-18RU)
Operation using the display is available only on MFR-16RUD.
 MFR-18RU is supported for crosspoint changes using the control knob in Setting mode.
 See section 5-3-2 "Mode Menu" for details.
 Control Assist Buttons
The following functionalities can be assigned to remote control panel buttons to assist
crosspoint switches.
 See section 6-1-1-1 "SKIP-FWD/SKIP BWD" for SKIP-FWD and SKIP-BWD
 See section 6-1-1-2 "TENKEY" for -TENKEY
Description Indications
- The selected destination button lights up.
- The button with the destination channel
indication will be highlighted.
- Menu display appears as shown below.
DST : 4 [DST4
LVL : 0001 [Level-1
- The selected source button lights up.
- The button with the source channel indication
will be highlighted.
71
]
]