Signal Name And Tally Link System; Configuration Example 1 - FOR-A MFR-1616 Operation Manual

3-3. Signal Name and Tally Link System

3-3-1. Configuration Example 1

The block diagram below shows an example signal name and tally link system comprised of
a FOR-A video switcher and multiviewer.
To configure this system, connect the SERIAL port on an MFR main unit or SERIAL 1 to 4
on an MFR-GPI unit to the video switcher's serial port. RS-422 ports are required for the
signal name and tally link system. Before connection, change the MFR serial ports from
RS-232C to RS-422 using the internal switches.
See section 2-3-4. "Switches on the Card."
SDI signal
SDI signal
35