Changing The Ru Network Settings - FOR-A MFR-1616 Operation Manual

5-7-2. Changing the RU Network Settings

The RU IP address and subnet mask can be changed as shown in the procedure below. In
the following procedure changes the MFR-16RU IP address from "192.168.1.100" to
"192.168.1.101."
Button locations vary depending on remote control units. Refer to the previous page for
button locations of other remote control units.
(1) Press Button D in Setup Menu mode. (If Button B or C is lit, press the lit button.)
(2) Press and hold down the right-most button (the fourth octet) of Buttons H. The button
will blink and the bottom eight buttons (Buttons I) display the value (100) by On and Off.
POWER
BUSY SETUP
LOCK RESET
(3) On the bottom row, press the right-most button of Buttons I to turn on the button. The
value will change to "101" (64+32+4+1).
POWER
BUSY SETUP
LOCK RESET
To change the first, second or third octet value, repeat steps (2) and (3), respectively.
To clear an octet value, press the flashing octet selection button on the upper row.
(4) When values are changed, Button G will blink. Press and hold down G to confirm the
change. The Remote Control Unit will automatically restart. To cancel the process, press
Button B or C without pressing G.
POWER
BUSY SETUP
LOCK RESET
A B
A B
A B
67
PAGE A
LOCK PANL
(HOLD 3SEC)
PAGE B
LOCK DEST
(HOLD 3SEC)
PAGE A
LOCK PANL
(HOLD 3SEC)
PAGE B
LOCK DEST
(HOLD 3SEC)
PAGE A
LOCK PANL
(HOLD 3SEC)
PAGE B
LOCK DEST
(HOLD 3SEC)
MFR-16RU
REMOTE CONTROL UNIT
MFR-16RU
REMOTE CONTROL UNIT
MFR-16RU
REMOTE CONTROL UNIT