Setup Menu (Other Remote Control Units) - FOR-A MFR-1616 Operation Manual

5-7. Setup Menu (Other Remote Control Units)

The SETUP button changes the RU to Setup Menu mode, which allows you to display RU and
MU PC-LAN network settings, reboot the MU PC-LAN port and change the RU network settings
To exit Setup Menu mode, press the SETUP button again.
 IP Address Display
The following procedure shows how to display an IP address in Setup Menu mode using
MFR-16RU as an example.
(1) Press SETUP. All idicators, POWER, BUSY and LOCK, turn on orange to indicate that the
RU enters in Setup Menu mode.
(2) Press Button D. (If Button B or C is lit, press the lit button.)
(3) Press the left-most button of H (the first octet button).
The number value will be displayed on the eight buttons of I. If the MFR-16RU IP address is
set to "192.168.1.100," "192" will be displayed on the eight buttons of I (8-bit) by indicating
On or Off.
POWER
BUSY SETUP
LOCK RESET
(4) Press the second button from the left (the second octet button) of H.
The number value will be displayed on the eight buttons of I.
If the MFR-16RU IP assress is set to "192.168.1.100," "168" will be displayed.
(5) Press the third button from the left (the third octet button) of H.
The number value will be displayed on the eight buttons of I.
If the MFR-16RU IP assress is set to "192.168.1.100," "1" will be displayed.
(6) Press the right-most button (the fourth octet button) of H.
The number value will be displayed on the eight buttons of I.
If the MFR-16RU IP address is set to "192.168.1.100," "100" (64+32+4) will be displayed as
shown below.
POWER
BUSY SETUP
LOCK RESET
A B
A B
65
PAGE A
LOCK PANL
(HOLD 3SEC)
PAGE B
LOCK DEST
(HOLD 3SEC)
PAGE A
LOCK PANL
(HOLD 3SEC)
PAGE B
LOCK DEST
(HOLD 3SEC)
MFR-16RU
REMOTE CONTROL UNIT
MFR-16RU
REMOTE CONTROL UNIT