Whirlpool ATE0743SPP Technical Manual page 41

8. Using a 5/32" allen wrench, loosen the
collar and clamp screws on the condenser
and evaporator fans.
Collar Screw
Evaporator
Fan
Clamp Screw
9. Remove the four hex-head screws from
the bottom of the fan motor brackets (2 on
each bracket).
Fan Motor Bracket Screw (1 of 4)
10. Remove the two hex-head screws from
11. Remove the remaining three hex-head
Condenser
Fan
12. From the rear of the unit, pull the defrost
13. Remove the two hex-head condenser
Screw
4-11
each of the condenser fan shroud mount-
ing brackets and remove the brackets.
screws from the condenser shroud (1 bot-
tom and 2 side screws).
Condenser
Fan Shroud
Side Screw (1 of 2)
sensing tube out of the condenser and
from behind the bracket, and move it out of
the way.
mounting screws from the chassis pan.
Sensor Tube
Bracket
Condenser
Continued on the next page.
Brackets &
Screws (2 each)
Bottom Screw
Screw