Table of Contents
Advertisement
3.4.20 Rebooting Clients through Your Local Network
The Reboot feature enables you to restart multiple clients through your local network without one by one going
through the restart procedure. Most of the time, adjusting client settings and updating client firmware require a
restart for those changes to take effect. With this feature, you are equipped with a necessary element for remote
and centralized management of a large number of endpoint devices.
Rebooting a Client through Your Local Network
To restart a client through your local network, please do the following:
1. On Thin Clients tab, click Thin Clients to expand the Client Group tree, and then click to select the client
group to which the desired client belongs.
2. The Client list appears.
3. Click to select the desired client, and then click Command to open the Command menu.
4. Click to select Reboot.
NOTE
• To select more than one client, Ctrl-click to select the desired clients.
WARNING
• Ensure that no important tasks are performed on the selected clients.
5. On the selected client, a warning message appears to notify the user of the planned reboot and allow the
user to cancel the action if necessary.
6. After completion, the Status icon will indicate the client is on-line again.
Using ViewSonic Device Manager
77
Managing All Your Clients
Advertisement
Table of Contents
