Table of Contents
Advertisement
3.3.5
Discovering Clients in a Specified Range of IP Addresses
To discover unmanaged clients in a specified range of IP addresses and add the desired client(s) into a managed
group under your ViewSonic Device Manager, please do the following:
1. On Scan tab, click to check Scan by IP Ranges.
2. The IP range fields appear.
3. Type in the desired IP range, and then click Start Scan.
4. On completion, the discovered clients are listed in Management area.
5. Select the desired client(s), the preferred client group from the drop-down menu on the top of the Client list,
and then click Put in group.
NOTE
• The default client group is Ungrouped. You can change the group of a client at a
later time. To create new client groups, please refer to section "3.4.3 Creating Client
Groups" on page 49.
• To select multiple clients, just click to select each individual client. You can also use
Select All and Unselect All on the top of the Client list to select/unselect clients.
6. On completion, the client(s) is managed by your ViewSonic Device Manager.
NOTE
• Whichever group you add a client to (including Ungrouped), once Put in group
is executed successfully, the client will be managed by your ViewSonic Device
Manager.
Using ViewSonic Device Manager
Adding Clients into a Managed Group
43
Advertisement
Table of Contents
