Table of Contents
Advertisement
Pushing Settings to a Client Group
To push settings to a client group, please do the following:
NOTE
• To ensure that your ViewSonic Device Manager is in sync with the setting values on
managed clients, it's recommended to pull client settings from all managed clients
for ViewSonic Device Manager before editing individualized client settings. For
detailed instructions on how to pull client settings from managed clients, please
refer to section "3.4.16 Pulling Client Settings through Your Local Network" on page
71.
1. On Thin Clients tab, click Thin Clients to expand the Client Group tree.
2. Right-click on the desired client group to open a popup menu, and then click to select Push Settings.
3. The Pushing Settings window appears showing the progress and result of pushing settings.
NOTE
• Ensure that all clients in the group are powered up. Otherwise, you may fail to
push settings to some clients. You can remotely know the current status of a client
through the Status icon in front of the client. For information on the Status icons,
please refer to section "3.4.7 Understanding Client Status Icons" on page 53.
4. After completion, click Close to exit.
5. Check the status of clients in the group through the Status icon in front of clients. If needed, restart clients to
complete the configuration changes on clients.
Using ViewSonic Device Manager
69
Managing All Your Clients
Advertisement
Table of Contents
