Restore System Configuration - Webdyn home Installation Manual

9.2 Restore system configuration

If you decide to perform a system restore, then the current installation configuration
will be completely overwritten and replaced by the previously backed up system
image. Be careful .... this even includes the IP address of the Webdynhome.
Please note that the system restore procedure must be performed using the Gateway
Tools that are supplied on the Webdynhome CDROM. There is a menu option in the
administration section but this is just used to remind users that they must launch the
gateway tools program.
The gateway tools restore procedure is described below :
a. Launch the Gateway Tools application.
b. Make sure that you have entered the
current connection parameters in the
Parameters menu tab (Webdynhome IP
address, user ID "install" and the installers
password)
c. Select the Restore menu tab
d. Browse the local PC disk or mapped
network drive (d: -> z:) and directory where
your backup image is stored and select the
exact file that you wish to restore.
Page 55