Physical Installation Procedures - Webdyn home Installation Manual

5 Physical installation procedures

As we have already seen the Webdynhome may be connected to several types
of infrastructure.
The connection to certain forms of infrastructure require different types of technical
expertise.
So whoever is about to undertake the installation of the Webdynhome must
have all of the necessary information before proceeding to the next stage of
this document.
Passwords
The Webdynhome must be personalized by assigning specific passwords to system
users. This information must only be known to the appropriate individuals.
IP address
You must know the IP addresses of the IP sub network to which the Webdynhome
will be assigned, the address of the Webdynhome itself and the addresses of any
network terminals or PC's that will be used to access the system.
Email addresses
You must know the email addresses of the users that will receive messages sent by
the Webdynhome.
X10 Power line equipment addresses
Each piece of equipment that forms part of the power line network is assigned an
address. This information is vital in order for the Webdynhome to be able to
communicate with these modules.
EIB equipment addresses
Each piece of equipment that forms part of the EIB installation is assigned a series
of EIB group addresses for specific functions. These addresses were configured
using ETS (EIB Tool Software) and a complete EIB installation map is automatically
produced by this software.
Sequences
After having configured all of the environmental equipment you can start the planning
process concerning the different sequences to be created. It is important to carefully
plan out the sequences before attempting the configuration process.
Page 13