Floor Sealing - Valor 956 Installer And Owner Manual

INSTALLER GUIDE
9. Pull each cable taut. Push the cable adjusters
hard up against the back panel. Tighten the
screws in the adjusters so that they clamp the
cables in position. Apply tension to the cables by
turning the hexagonal adjusters by hand (See
figure 17).
10. Inspect the installation of the hotbox against
the fireplace surround. If the hotbox is aligned
squarely and the sealing is satisfactory, fully
tighten the cable adjusters.
11. If the hotbox is not correctly aligned, release
the tension on the cables by slackening the
screws and turning the hexagonal adjusters fully
anticlockwise. The hotbox should then
automatically realign itself. Pull each cable taut
again and push the cable adjusters back against
the back panel. Again, tighten the screws in the
adjusters and apply tension to the cables by
turning the hexagonal adjusters clockwise as far
as possible.
12. Do not cut off any excess cable, instead coil
up the cable so that they are available to allow
easy removal and refitting of the appliance
Figure 17. Lower cable retention
during subsequent service calls.

10.3 Floor sealing.

Using the floor sealing tape supplied, seal the
bottom of the hotbox to the fireplace and hearth
floor. Run the tape over the centre bracket (See
figure 18).
Figure 18. Floor sealing
©
GDC Group Ltd 2014
Page 26