Fascia And Firefront Installation; Fitting A Firefront That Has Not Been Supplied With The Fire; Fitting The Magnetic Three Piece Fascia Trim; Fitting The Blenheim Firefront - Valor 956 Installer And Owner Manual

13. FASCIA AND FIREFRONT INSTALLATION

13.1 Fitting a firefront that has not been supplied with the fire.

- A slotted firefront with a minimum free area as shown in figure 22 must always be
used.
Figure 22. Firefront minimum open area requirements
(The firefront may differ from that shown)
- For models supplied with a Valor Fires firefront, the open area may differ slightly
from that stated in figure 22. In these cases the firefront will have been tested with the
fire and found to be satisfactory for use with the fire.

13.2 Fitting the magnetic three piece fascia trim.

1. The fascia is supplied in three pieces. Carefully remove the three pieces from the
packaging. Remove any protective film.
2. The magnets used to locate each trim should already be positioned on the rear of
each trim. Each trim should have two magnets. If the magnets are not fitted then
locate one magnet centrally at each end of the trims.
3. Locate the side trims as in figure 23.
4. Locate the top trim as in figure 23.
5. The Siva fascia trim is already assemblied and can be located as in Figure 23 but
all in one piece.
©
GDC Group Ltd 2014
INSTALLER GUIDE
Page 30