To Remove The Burner; To Remove The Main Burner Injector; To Remove The Appliance From The Fireplace; To Remove The Magnetic Three Piece Fascia - Valor 956 Installer And Owner Manual

16.6 To remove the main burner injector.

(See figure 33).
1. Remove the burner (See section 16.5).
2. Remove the burner clamping screw (See figure
33).
3. Unscrew the injector from the burner.
4. Refit in the reverse order.
16.7 To remove the appliance from the
fireplace.
1. Remove the burner unit (See section 16.2).
2. Slacken the hexagonal adjusters on the cable
adjusters and unscrew the thumbscrews to
release the cables.
3. Refit as described in the relevant installation
sections. Make sure gas soundness, sealing,
spillage test and performance are satisfactory.
16.8 To remove the magnetic three piece
fascia.
1. Remove the firefront.
2. The fascia is made up of three trims. These
trims are held in place by magnets. Remove the
top trim by pulling forward. Place carefully
aside (See figure 34).
3. Remove the side trims by pulling forward.
Place carefully aside (See figure 34).
4. Refit in the reverse order. Make sure that
the top corners of the fascia have no gaps.
5. Siva fascia same as in Figure 34 except the
fascia is all one piece.
©
GDC Group Ltd 2014
INSTALLER GUIDE
Page 37
Figure 32. Removal of burner
Figure 33. Main burner injector
removal
Figure 34. Removal of fascia