Interface Selection; Setting The Interface - Datalogic Gryphon I GFS4100 Product Reference Manual

Interface Selection

Upon completing the physical connection between the reader and its host, proceed to Table 1
starting on page 14
or USB). Scan the appropriate barcode in that section to configure your system's correct
interface type.
Each reader model will support one of the following sets of host interfaces:
GFS4150-9 Model
•
•

Setting the Interface

Scan the programming barcode from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding
section in this manual (also listed in Table 1
settings and features associated with that interface.
Product Reference Guide
to select the interface type the reader is connected to (for example, RS-232
RS-232-STD
RS-232 Wincor-Nixdorf
Unlike some programming features and options, interface selections
require that you scan only one programming barcode label. DO NOT scan
an ENTER/EXIT barcode prior to scanning an interface selection barcode.
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will
change to a state that allows programming with barcodes.
GFS4170 Model
• USB-COM, USB-KBD, USB_KBD-ALT,
USB-KBD-Apple
starting on page 14) to configure any desired
Interface Selection
13