Good Read Led Duration - Datalogic Gryphon I GFS4100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 100 milliseconds to 25,500
milliseconds (0.1 to 25.5 seconds) in 100ms increments.
page 251
See
Select Good Read LED Duration Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
Product Reference Guide
in "References" for detailed instructions and examples for setting this feature.
DEFAULT
All LED indicators are off during sleep.
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT barcode again.
CANCEL
001 = Good Read LED
stays on for 100 ms.
Good Read LED Duration
69