Command Syntax - Datalogic Gryphon I GFS4100 Product Reference Manual

Software Configuration Strings

Command Syntax

1. Enter Service (Serial String Programming) Mode
2. Send Command
Where:
Command:
Parameter:
Value:
3. Apply and Save Configuration to FLASH (permanent memory) and Exit Service Mode
208
This command automatically sets the reader communication to
115200 baud rate. Before continuing, please set the baud rate of
the Terminal Emulation Program to 115200.
HAXX Interface Selection
AA Enable All Symbologies
AD Disable All Symbologies
R Reset Reader
CXXXXXX Write Single Configuration Item to RAM
A 4-character ASCII string 
XXXX
See Serial Configuration Strings Table
A 2-character Hex string 
XX
See Serial Configuration Strings Table
This command automatically returns to the programmed baud
rate. Before continuing, please set the baud rate of the Terminal
Emulation Program to the programmed baud rate.
$S<CR>
Description
$Ar<CR>
Gryphon™ I GFS4170/GFS4150-9