Configuration Using Barcodes; Configuration Parameters - Datalogic Gryphon I GFS4100 Product Reference Manual

This and following sections provide programming barcodes to configure your reader by
changing the default settings. For details about additional methods of programming, see
Configuration Methods on page

Configuration Parameters

Once the reader is set up, you can change the default parameters to meet your application needs.
Refer to
default values and select the interface for your application.
The following configuration parameters are applicable to all Gryphon models covered in this
manual, unless otherwise indicated. The items are divided into logical groups, making it easy to
find the desired function based on its reference group.
Interface Configuration:
• "RS-232 ONLY Interface" on page 21
• "RS-232/USB-Com Interfaces" on page 26
"USB Keyboard Interfaces" on page 33
•
Parameters common to all interface applications:
"Data Format" on page 41
•
"Reading Parameters" on page 65
•
functioning.
Symbology-specific parameters:
• "Code Selection" on page 77
families and their options.
Product Reference Guide

Configuration Using Barcodes

9.
You must first enable your reader to read barcodes in order to use this
section. If you have not done this, go to
complete the appropriate procedure.
"Standard Defaults" starting on page 263
gives options to control the messages sent to the Host system.
provides configuration of a personalized mix of codes, code
Setup, starting on page 11
for initial configuration in order to set the
control various operating modes and indicators status
Chapter 3
and
17