Ack Nak Timeout Value; Ack Nak Retry Count - Datalogic Gryphon I GFS4100 Product Reference Manual

RS-232/USB-Com Interfaces

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout.
page 237
See
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
DEFAULT

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and
a selection of 255 specifies unlimited retries. See
Select ACK NAK Retry Count Setting
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
30
for more information on setting this feature.
01 ACK NAK Timeout value is 200ms
DEFAULT
ENTER/EXIT PROGRAMMING MODE
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the barcode at
left followed by the digits (in hex) from the Alphanumeric
Appendix D, Keypad
characters in
character(s). End by scanning the ENTER/EXIT barcode again.
page 238 for more information.
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE barcode above, then the barcode at left followed
by the digits (in hex) from the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT barcode again.
003 = 3 Retries
Gryphon™ I GFS4170/GFS4150-9
representing your desired
CANCEL
CANCEL