RS-232/USB-Com Interfaces
Disable Character
Specifies the value of the RS-232 host command used to disable the reader. ASCII characters or
any hex value from 0 to 0xFF can be selected.
page 239
See
Select Disable Character Setting
Enable Character
Specifies the value of the RS-232 host command used to enable the reader. ASCII characters or
any hex value from 0 to 0xFF can be selected.
page 240
See
Select Enable Character Setting
32
Setting to previously defined characters such as XON, XOFF or host com-
mands conflicts with normal operation of these characters. 8-bit data is
not recognized when
for more information on setting this feature.
DEFAULT
Setting to previously defined characters such as XON, XOFF or host com-
mands conflicts with normal operation of these characters. 8-bit data is
not recognized when
in "References" for more information on setting this feature.
DEFAULT
The Enable/Disable Characters must be different and must not contain
reserved characters (see
ENTER/EXIT PROGRAMMING MODE
Data Bits
are set as 7 Data Bits.
0x44 = Disable Character is 'D'
Data Bits
are set as 7 Data Bits.
0x45 = Enable Character is 'E'
Appendix E, Reserved Characters
)
Gryphon™ I GFS4170/GFS4150-9