Audio Note L2 Line Preamplifier Instruction Manual page 63

Step 2: Prepare a twisted PTFE pair.
Copyright © 2007, 2008 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Now connect a ground wire – Black –
from the NOBLE PCB Ground to either
the LINGND or the RINGND (these
are connected internally).
That should do it! We now have a completed wiring for a
single Line Stereo Input for your pre-amp! You can do a
quick tie wrap to clean up some of the wiring.
You can now add your required number of extra line inputs
or wait until you have carried out the test outlined in the
next section.
Take one end and strip the ends off with wire strippers.
Then tin the ends by adding solder to them – see opposite.
Page 63