Audio Note L2 Line Preamplifier Instruction Manual page 62

Copyright © 2007, 2008 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Here we can see the wire soldered to
the Noble PCB.
Now take the wire and solder to the
ELMA selector – The red wire would
go on the RIGHT side of the ELMA
output and the black wire on the LEFT
side of the ELMA output (see ELMA
graphic).
Here is our wiring up to this point.
Check the following:
The PTFE wire from the RCA's to the ELMA
•
The grounds from the RCA to the Noble PCB
•
The PTFE wire from the output of the ELMA (central
•
pins) to the input of the NOBLE PCB.
Next wiring step is to connect the
OUTPUT of the Noble Pot to the
inputs of the Line Board that you have
completed.
For the Output of the Noble PCB
connect the red wire to the RIN and
the Black wire to the LIN (these are
our right and left audio signals).
Page 62